LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Emissions Control System) >> Exhaust Gas RECIRCULATION Valve >> Sensor - EGR Back Pressure >> Installation

Sensor - EGR Back Pressure: Installation

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the EGR back pressure sensor.
  2. Connect the engine wiring harness electrical connector.
  3. Install the engine cover.
  4. Connect the negative battery cable.
scientia non olet · About LEMON Manuals