LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Emissions Control System) >> Exhaust Gas RECIRCULATION Valve >> Assembly-Exhaust Gas RECIRC Valve >> Removal >> 2.7L

Assembly-Exhaust Gas RECIRC Valve: Removal: 2.7L

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: EGR System
GC0014026Courtesy of DAIMLERCHRYSLER CORP.
  1. EGR system components and location. Upper tube (2), EGR valve (1), and Lower tube (3).
  2. Disconnect negative battery cable.
    Fig 2: Purge Solenoid Installed
    GC0014018Courtesy of DAIMLERCHRYSLER CORP.
  3. Remove purge solenoid from bracket.
    Fig 3: Purge Solenoid Bracket
    GC0014017Courtesy of DAIMLERCHRYSLER CORP.
  4. Relocate the purge solenoid.
  5. Unlock and disconnect the electrical connector from EGR valve.
    Fig 4: EGR Valve And Tubes
    GC0014027Courtesy of DAIMLERCHRYSLER CORP.
  6. Remove the bolts from the EGR tube to exhaust manifold.
  7. Remove the lower tube bolts to EGR valve and remove tube(3).
  8. Remove upper tube bolts to EGR valve (2).
  9. Remove the EGR valve mounting bolts (1).
  10. Remove valve from vehicle.
  11. Clean mounting surface.
scientia non olet · About LEMON Manuals