Evaporative Emissions: Canister-Vapor: Removal

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Canister Installed

Courtesy of DAIMLERCHRYSLER CORP.

Disconnect negative battery cable.
Raise vehicle and support.
Remove the right rear tire.
Remove the inner splash shield.

Fig 2: NVLD Electrical Connector
Courtesy of DAIMLERCHRYSLER CORP.
Disconnect the EVAP line.
Unlock and disconnect electrical connector from pump.

Fig 3: Canister Assembly Exploded
Courtesy of DAIMLERCHRYSLER CORP.
Remove mounting nut.

Fig 4: Rubber Mounts and Brackets
Courtesy of DAIMLERCHRYSLER CORP.
Slide assembly forward off of rear mounting brackets.

Fig 5: Rubber Mounts Installed
Courtesy of DAIMLERCHRYSLER CORP.
Make sure that you do not lose the rubber mounts in canister brackets.

Fig 6: Canister Hose Connected
Courtesy of DAIMLERCHRYSLER CORP.
Disconnect vapor lines from EVAP canister.

Fig 7: Canister Hoses
Courtesy of DAIMLERCHRYSLER CORP.
Squeeze connector and pull.

Fig 8: Canister Bracket Nuts
Courtesy of DAIMLERCHRYSLER CORP.
Remove mounting nuts from canister.
Remove vapor canister from bracket.