LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Emissions Control System) >> Evaporative Emissions >> Canister-Vapor >> Installation

Evaporative Emissions: Canister-Vapor: Installation

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Canister Bracket Nuts
GC0014019Courtesy of DAIMLERCHRYSLER CORP.
  1. Install canister to bracket and tighten nuts.
    Fig 2: Canister Hoses
    GC0014023Courtesy of DAIMLERCHRYSLER CORP.
  2. Connect hoses to vapor canister.
    Fig 3: Canister Hose Connected
    GC0014025Courtesy of DAIMLERCHRYSLER CORP.
  3. Hose connected.
    Fig 4: Rubber Mounts Installed
    GC0014022Courtesy of DAIMLERCHRYSLER CORP.
  4. Install rubber isolator in canister brackets.
    Fig 5: Rubber Mounts and Brackets
    GC0014020Courtesy of DAIMLERCHRYSLER CORP.
  5. Slide canister brackets with rubber isolators onto mounting brackets.
    Fig 6: Canister Assembly Exploded
    GC0014014Courtesy of DAIMLERCHRYSLER CORP.
  6. Install assembly mounting nut.
    Fig 7: NVLD Electrical Connector
    GC0014024Courtesy of DAIMLERCHRYSLER CORP.
  7. Connect electrical connector to pump and lock.
    Fig 8: Canister Installed
    GC0014016Courtesy of DAIMLERCHRYSLER CORP.
  8. Connect the EVAP line.
  9. Install the inner splash shield.
  10. Install tire.
  11. Lower vehicle.
  12. Connect negative battery cable.
scientia non olet · About LEMON Manuals