Diagnostic Test
WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
- 1) CHECK PCM FOR CHARGING SYSTEM DTC
With the scan tool, record and erase DTC's.
Cycle the ignition switch from On to Off.
Start the engine.
Run the engine at approximately 1500 RPM for 1 minute.
With the scan tool, read DTCs.
With the scan tool, read Powertrain Control Module DTC's.
Are there any Charging System DTC's set in the Powertrain Control Module?
Yes
- (Refer to CHARGING ) for Charging System diagnostic procedures.
- Perform BODY VERIFICATION TEST - VER 1. (Refer to BODY VERIFICATION TEST - VER 1 ).
No
- The conditions that caused this code to set are not present at this time. Using Service Information, check the charging system.
- Perform BODY VERIFICATION TEST - VER 1. (Refer to BODY VERIFICATION TEST - VER 1 ).