Vacuum Reservoir: Removal

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Inner Splash Shield

Courtesy of DAIMLERCHRYSLER CORP.

The vacuum reservoir is located in the right front fender well on the frame rail. It is made of plastic.

Remove the air cleaner lid, disconnect the inlet air temperature sensor and makeup air hose.
Remove the negative battery cable.
Raise vehicle and support.
Remove the right front wheel.
Remove the front half of the inner splash shield and relocate rearward.

Fig 2: Reservoir Mounting Screws
Courtesy of DAIMLERCHRYSLER CORP.
Remove the 2 screws from vacuum reservoir.

Fig 3: Identifying Vacuum Reservoir
Courtesy of DAIMLERCHRYSLER CORP.

1 - VACUUM RESERVOIR
Disconnect vacuum hose from reservoir (1).