LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 122 (Cruise Control Systems) >> Servo >> Removal >> 2.4L Turbo

2.4L Turbo

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Battery Negative Cable
GC0020023Courtesy of DAIMLERCHRYSLER CORP.
  1. Disconnect the negative battery cable.
    Fig 2: Throttle Control Shield
    GC0021943Courtesy of DAIMLERCHRYSLER CORP.
  2. Remove the throttle control shield. See Figure.
  3. Remove the speed control cable from the throttle body lever.
  4. Remove the vacuum line from the speed control servo. See Figure.
    Fig 3: Speed Control Servo - 2.4L Turbo
    GC0021945Courtesy of DAIMLERCHRYSLER CORP.
  5. Remove the 2 nuts from the speed control servo studs. See Figure.
  6. Push and pull up the speed control servo from the mounting bracket.
  7. Unlock and disconnect the electrical connector from the speed control servo. See Figure.
  8. Remove the 2 push clips and discard.
    Fig 4: Cable Retaining Clip
    GC0021942Courtesy of DAIMLERCHRYSLER CORP.
    1 - HAIRPIN CLIP
  9. Remove the retaining clip (1) holding cable to servo. See Figure.
scientia non olet · About LEMON Manuals