LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 121 (Wiring Diagram Information) >> Wiring Diagram Information >> Standard Procedure >> Standard Procedure - Testing For Continuity

Standard Procedure - Testing For Continuity

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Testing for Continuity
GC0002524Courtesy of DAIMLERCHRYSLER CORP.
1 - FUSE REMOVED FROM CIRCUIT
  1. Remove the fuse (1) for the circuit being checked or, disconnect the battery.
  2. Connect one lead of the ohmmeter to one side of the circuit being tested
  3. Connect the other lead to the other end of the circuit being tested. Low or no resistance means good continuity.
scientia non olet · About LEMON Manuals