Resonator - 5.7L: Removal
WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - ISOLATOR |
| 2 - NUT |
| 3 - MUFFLER AND TAILPIPE ASSEMBLY |
| 4 - BALL FLANGE |
| 5 - LH RESONATOR AND TAILPIPE ASSEMBLY |
WARNING:
THE NORMAL OPERATING TEMPERATURE OF THE EXHAUST SYSTEM IS VERY HIGH. THEREFORE, NEVER WORK AROUND OR ATTEMPT TO SERVICE ANY PART OF THE EXHAUST SYSTEM UNTIL IT IS COOLED. SPECIAL CARE SHOULD BE TAKEN WHEN WORKING NEAR THE CATALYTIC CONVERTER. THE TEMPERATURE OF THE CONVERTER RISES TO A HIGH LEVEL AFTER A SHORT PERIOD OF ENGINE OPERATION TIME.
- Raise vehicle.
- Remove two nuts (2).
- Remove isolators (1).
- Remove LH resonator and tailpipe assembly (5).