Resonator - 5.7L: Installation
WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - ISOLATOR |
| 2 - NUT |
| 3 - MUFFLER AND TAILPIPE ASSEMBLY |
| 4 - BALL FLANGE |
| 5 - LH RESONATOR AND TAILPIPE ASSEMBLY |
- Position LH resonator and tailpipe assembly (5) in vehicle.
- Install isolators (1).
- install ball flange nuts (2). Tighten nuts finger tight.
- Check clearance between muffler and tailpipe assembly and fuel tank. Clearance is 14mm (.55 in.) for V8 engine and 16mm (.62 in.) for V6 engine.
- Check clearance at rear tunnel reinforcement. Clearance is 15 - 20mm (.59 -.78 in.).
- The tailpipe should be centered in the rear fascia opening.
- Tighten ball flange nuts (2) to 47 N.m (35 ft. lbs.).
- Lower vehicle.
- Start the engine and inspect for exhaust leaks. Repair exhaust leaks as necessary.