LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Exhaust System) >> Catalytic Converter >> Removal >> Left Hand Catalytic Converter

Left Hand Catalytic Converter

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: LH Catalytic Converter
GC0012937Courtesy of DAIMLERCHRYSLER CORP.
1 - OXYGEN SENSOR
2 - OXYGEN SENSOR CONNECTOR
3 - BALL FLANGE NUT
4 - LH CATALYTIC CONVERTER
  1. Raise vehicle on hoist.
  2. Hoist vehicle.
    WARNING: The normal operating temperature of the exhaust system is very high. therefore, never work around or attempt to service any part of the exhaust system until it is cooled. special care should be taken when working near the catalytic converter. The temperature of the converter rises to a high level after a short period of engine operation time.
  3. Disconnect downstream oxygen sensor electrical connectors.
  4. Remove muffler and resonator assembly (Refer to EXHAUST SYSTEM/MUFFLER - REMOVAL) .
  5. Remove ball flange nuts.
  6. Remove catalytic converter ball flange nut.
  7. Remove catalytic converter.
scientia non olet · About LEMON Manuals