Power Mirror Switch - LHD: Installation
WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
- Place the mirror switch in cover opening and firmly snap into place.
- Connect the power mirror switch wiring connector.
- Place the left end cover in position and snap into place. Make sure that it is underneath the A-pillar trim and top cover.
- Install two screws to the left instrument panel end cover.
- Place left lower instrument panel bezel in position and make sure the orientation of the hinge is correct and snap bezel hinge into place
- Roll bezel upward and snap into place.
- Connect the battery negative cable.