Diagnosis And Testing - Power Mirror Switch - LHD
WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect and isolate the battery negative cable.
- Remove power mirror switch (Refer to ELECTRICAL/POWER MIRRORS/POWER MIRROR SWITCH - REMOVAL) .
- Using an ohmmeter, test for continuity between the terminals of the switch as shown in the Mirror Switch Test table.
- If test results are not obtained as shown in the Mirror Switch Test table, replace the switch.
MIRROR SWITCH TEST TABLE
|
SWITCH POSITION MOVE BUTTON |
CONTINUITY BETWEEN TERMINALS |
| MIRROR IN "L" POSITION | |
| UP |
PIN 2 TO 4 PIN 4 TO 7 PIN 8 TO 10 |
| RIGHT |
PIN 3 TO 8 PIN 8 TO 9 PIN 4 TO 10 |
| DOWN |
PIN 2 TO 8 PIN 7 TO 8 PIN 4 TO 10 |
| LEFT |
PIN 3 TO 4 PIN 4 TO 9 PIN 8 TO 10 |
| MIRROR IN "R" POSITION | |
| UP |
PIN 2 TO 4 PIN 4 TO 7 PIN 1 TO 8 |
| RIGHT |
PIN 1 TO 4 PIN 3 TO 8 PIN 8 TO 9 |
| DOWN |
PIN 1 TO 4 PIN 2 TO 8 PIN 7 TO 8 |
| LEFT |
PIN 3 TO 4 PIN 1 TO 8 PIN 4 TO 9 |