LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 116 (Wiper System & Washer System (Service Information)) >> Washer Reservoir >> Removal

Washer Reservoir: Removal

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open hood.
  2. Disconnect and isolate the battery negative cable.
  3. Using a trim stick (special tool # C-4755) or equivalent, gently pry up on the wiper arm nut cap and remove. See Figure.
  4. Remove wiper arm retaining nut. See Figure.
  5. Remove the arm from the pivot using a rocking motion while the arm is in an over/centered position. See Figure.
  6. Remove the right cowl cover. The right side cover overlaps the left side cover.
    • Remove the rear engine compartment seal at the cowl.
    • Remove the four push retainers to the right side cowl cover and remove from vehicle.
  7. Remove three reservoir retaining screws.
  8. Disconnect the pump wire connector.
  9. Disconnect the washer hose connections.
  10. Lift washer reservoir out of cowl area and drain into bucket.
    NOTE: If replacing the washer reservoir, the washer pump must be transferred to the new reservoir. The new reservoir will come with a new washer pump grommet.
  11. Remove plastic strap from around pump.
  12. Gently pry pump away from reservoir and out of grommet.
scientia non olet · About LEMON Manuals