LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 116 (Wiper System & Washer System (Service Information)) >> Washer Reservoir >> Installation

Washer Reservoir: Installation

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
  1. Insert pump into pump grommet.
  2. Place plastic strap over pump assembly and snap firmly into the reservoir.
  3. Place reservoir into cowl area and connect the washer hoses.
    NOTE: The hose with the white stripe goes on the white side of the pump and the black hose on the black side of the pump.
  4. Connect the pump wire connector.
  5. Install the three reservoir retaining screws. Torque screws to 8 N.m (70 in. lbs.).
  6. Install the cowl cover. The right side cover overlaps the left side cover.
    • Place the right side cowl cover into position and install the four push retainers.
    • Install the rear engine compartment seal at the cowl.

    Before installation of the front wiper arms, activate the wiper system to ensure the front wiper module is in the PARK position. Position wiper arms so that the tip of the driver's blade and the middle of the passenger's blade is on the park line on the windshield (Refer to ELECTRICAL/WIPERS/WASHERS/WIPER ARMS - ADJUSTMENTS) .

  7. Place the arm on the pivot while the arm is in an over/centered position. See Figure.
  8. Install the wiper arm retaining nut and torque to 21 N.m (190 in. lbs.). See Figure.
  9. Install the wiper arm nut cap. See Figure.
  10. Connect the battery negative cable.
  11. Close hood.
  12. Verify vehicle and system operation.
scientia non olet · About LEMON Manuals