LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 116 (Wiper System & Washer System (Service Information)) >> Washer Pump Motor >> Removal

Washer Pump Motor: Removal

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Front Wiper Arm
GC0021955Courtesy of DAIMLERCHRYSLER CORP.
  1. Open hood.
  2. Disconnect and isolate the battery negative cable.
  3. Using a trim stick (special tool #C-4755) or equivalent, gently pry up on the wiper arm nut cap and remove.
  4. Remove wiper arm retaining nut.
  5. Remove the arm from the pivot using a rocking motion while the arm is in an over/centered position.
    Fig 2: Removing/Installing Washer Reservoir
    GC0021967Courtesy of DAIMLERCHRYSLER CORP.
  6. Remove the right cowl cover.
    • Remove the rear engine compartment seal at the cowl.
    • Remove the four push retainers to the right side cowl cover and remove from vehicle.
  7. Remove three reservoir retaining screws.
  8. Disconnect the pump wire connector.
  9. Disconnect the washer hose connections.
  10. Lift washer reservoir out of cowl area and drain into bucket.
  11. Remove plastic strap from around pump.
  12. Gently pry pump away from reservoir and out of grommet. Care must be taken not to puncture reservoir.
  13. Remover rubber grommet from reservoir.
scientia non olet · About LEMON Manuals