Washer Pump Motor - RHD: Installation

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: A new grommet must be used every time the pump is removed/installed from the reservoir to prevent possible leaks in the future.

Install new grommet into the reservoir.
Insert pump into pump grommet and firmly snap into reservoir.
Place plastic strap over pump assembly and snap firmly into the reservoir.
Place reservoir into cowl area and connect the washer hoses.
NOTE: The hose with the white stripe goes on the white side of the pump and the black hose on the black side of the pump.
Connect the pump wire connector.
Install the three reservoir retaining screws. Torque screws to 8 N.m (70 in. lbs.).
Install the cowl cover. The left side cover overlaps the right side cover.
- Place the left side cowl cover into position and install the four push retainers.
- Install the rear engine compartment seal at the cowl.
Before installation of the front wiper arms, activate the wiper system to ensure the front wiper module is in the PARK position. Position wiper arms so that the tip of the driver's blade and the middle of the passenger's blade is on the park line on the windshield (Refer to ELECTRICAL/WIPERS/WASHERS/WIPER ARMS - ADJUSTMENTS) .
Place the arm on the pivot while the arm is in an over/centered position. See Figure.
Install the wiper arm retaining nut and torque to 21 N.m (190 in. lbs.). See Figure.
Install the wiper arm nut cap. See Figure.
Connect the battery negative cable.
Close hood.
Verify vehicle and system operation.