LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 116 (Wiper System & Washer System (Service Information)) >> Right Multi-Function Switch >> Installation

Right Multi-Function Switch: Installation

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Right Multi-Function Switch Harness Connector
GC0042965Courtesy of DAIMLERCHRYSLER CORP.
  1. Position the right multi-function switch to the back of the Steering Column Control Module (SCCM) (3) and connect the switch connector (1).
    Fig 2: Right Multi-Function Switch Retaining Screw
    GC0042964Courtesy of DAIMLERCHRYSLER CORP.
  2. Align switch with the SCCM (2) and slide toward steering column.
  3. Install the screw (3) that secures the switch (2) to the SCCM (1).
  4. Install the upper and lower shrouds onto the steering column. (Refer to SHROUD-UPPER and SHROUD-LOWER .
  5. Connect the battery negative cable.
scientia non olet · About LEMON Manuals