LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 116 (Wiper System & Washer System (Service Information)) >> Rear Wiper Motor >> Removal

Rear Wiper Motor: Removal

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Rear Wiper Arm
GC0021964Courtesy of DAIMLERCHRYSLER CORP.
  1. Open hood.
  2. Disconnect and isolate the battery negative cable.
  3. Remove the rear wiper arm nut cap.
  4. Remove wiper arm retaining nut.
    Fig 2: Disengaging Wiper Arm from Pivot Shaft
    GC0012206Courtesy of DAIMLERCHRYSLER CORP.
  5. Use a battery terminal puller to remove the wiper arm from the wiper pivot.
    Fig 3: Removing/Installing Rear Wiper Motor
    GC0021966Courtesy of DAIMLERCHRYSLER CORP.
  6. Remove liftgate trim panel (Refer to BODY/DECKLID/HATCH/LIFTGATE/TAILGATE/TRIM PANEL - REMOVAL) and (Refer to BODY/DECKLID/HATCH/LIFTGATE/TAILGATE/TRIM PANEL - REMOVAL) .
  7. Disconnect harness connector.
  8. Remove three machine screws to the rear wiper motor and remove from vehicle.
CAUTION: Use extreme care when taking out motor. Damage to the grommet and or window can occur.
scientia non olet · About LEMON Manuals