Front Wiper Motor - RHD: Installation
WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
- Place the motor on the wiper linkage and install the three bolts to the front wiper motor.
- Connect drive link to motor crank ball joint.
- Place the front wiper module into cowl area and install the three mounting bolts. Torque the mounting screws to 8 N.m (75 in. lbs.).
- Connect the front wiper motor posi-lock harness connector.
- Install the cowl cover. The right side cover overlaps the left side cover.
- Place the left side cowl cover into position and install the three push retainers.
- Place the right side cowl cover into position and install the four push retainers.
- Install the rear engine compartment seal at the cowl.
Before installation of the front wiper arms, activate the wiper system to ensure the front wiper module is in the PARK position. Position wiper arms so that the tip of the driver's blade and the middle of the passenger's blade is on the park line on the windshield (Refer to ELECTRICAL/WIPERS/WASHERS/WIPER ARMS - ADJUSTMENTS) .
- Place the arm on the pivot while the arm is in an over/centered position.
- Install the wiper arm retaining nut and torque to 21 N.m (190 in. lbs.).
- Install the wiper arm nut cap.
- Connect the battery negative cable.
- Close hood.