Rear Seat: Removal: Convertible

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Check Strap

Courtesy of DAIMLERCHRYSLER CORP.

1 - CHECK STRAP

2 - ATTACHING SCREW

Fold rear seats forward and remove screw (2) attaching check strap (1) on each side of vehicle.
Remove latch covers. (Refer to BODY/SEATS/REAR SEAT LATCH COVERS - REMOVAL) .

Fig 2: PT27 Seat Latch And Latching Device
Courtesy of DAIMLERCHRYSLER CORP.

1 - LATCHING DEVISE
Fold seat back down and then roll forward to access rear seat latch latching devices (1).

Fig 3: PT27 Seat Latch
Courtesy of DAIMLERCHRYSLER CORP.

1 - ROD
To disengage latching devise, rock latching devise rearward and install a rod (1) into the hole to support latching devise in the open position.

Fig 4: Rear Seat Latches
Courtesy of DAIMLERCHRYSLER CORP.

1 - LATCH(S)

With both latches (1) in the open position the seat may be removed.

Fig 5: Pivot Bracket(s)

Courtesy of DAIMLERCHRYSLER CORP.

1 - REAR FLOOR PAN

2 - REAR SEAT LATCH(S)

3 - ATTACHING BOLTS

Remove latches (2), if necessary. Remove attaching bolts (3) and remove latch (2).