LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 114 (Interior & Exterior (2 Of 2)) >> Seats >> Rear Seat Back Cushion / Cover >> Installation

Rear Seat Back Cushion / Cover: Installation

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: SEAT CUSHION FRAME, BACK FRAME, PIVOT
GC0043116Courtesy of DAIMLERCHRYSLER CORP.
  1. Position seat cover on cushion.
  2. Align seat cover with cushion alignment indentations.
  3. Install hog rings.
  4. Engage J-strap attaching seat cover to front of seat cushion frame.
  5. Install track assembly. Tighten front track to pan bolts to 12 N.m (9 ft. lbs.).
    Fig 2: SEAT BACK TRIM
    GC0043115Courtesy of DAIMLERCHRYSLER CORP.
  6. Install seat back.
  7. Install rear seat cushion side shields.
  8. Install seat in vehicle.
scientia non olet · About LEMON Manuals