LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 114 (Interior & Exterior (2 Of 2)) >> Interior >> Liftgate >> Hinge >> Removal

Section 114 (Interior & Exterior (2 Of 2)): Interior: Liftgate: Hinge: Removal

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Liftgate Hinge
GC0022437Courtesy of DAIMLERCHRYSLER CORP.
  1. Release liftgate latch and open liftgate (1).
  2. Remove the trim panels as necessary from the side of the vehicle being serviced and lower the rear of the headliner to gain access to the liftgate hinge bolts (Refer to BODY/INTERIOR/HEADLINER - REMOVAL) .
  3. Support liftgate with a suitable lifting device in the full open position on the side of the vehicle being serviced.
  4. Apply several layers of duct tape on the outside of to roof across the gap to the liftgate to hold the liftgate in position on the side of the vehicle being serviced.
  5. Remove the two bolts that secure the liftgate hinge (2) to the liftgate.
  6. Remove the three bolts that secure the liftgate hinge to the roof header (3) and remove the hinge.
scientia non olet · About LEMON Manuals