LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 114 (Interior & Exterior (2 Of 2)) >> Interior >> Liftgate >> Control-Latch >> Removal

Section 114 (Interior & Exterior (2 Of 2)): Interior: Liftgate: Control-Latch: Removal

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Linkage And Electrical Connectors Removal/Installation
GC0022435Courtesy of DAIMLERCHRYSLER CORP.
  1. Disconnect and isolate the negative battery cable.
  2. Remove the liftgate trim panel (Refer to BODY/DECKLID/HATCH/LIFTGATE/TAILGATE/PANEL-TRIM - REMOVAL)  .
  3. Disconnect the liftgate wire harness connectors (1) and disengage the connector retainer from the liftgate latch control (3).
  4. Disengage the retainer clips that secure the linkage rods (2) to the latch control and disconnect the linkage rods.
  5. Remove the two bolts that secure the latch control to the liftgate and remove the control.
scientia non olet · About LEMON Manuals