Specifications - Body Gap And Flush Measurements - Coupe

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

INDEX

DESCRIPTION	FIGURE
BODY GAP AND FLUSH	Fig 1.

Fig 1: Body Gap And Flush

Courtesy of DAIMLERCHRYSLER CORP.

	LOCATION	GAP	FLUSH
1	Hood to Grille	// within 2.0	Grille Ends 5.0
			Grille Center 7.0
			Under flush +/- 1.5
2	Hood to Fender	6.0 +/- 1.0 // 1.0	Fender Front Overflush 1.5 +/- 1.0
			Fender Middle & Rear +/- 1.0
			Consistent Within 1.0
3	Hood to Door	5.0 +/- 1.0 // 1.0	+/- 1.5 Consistent within 1.0
4	Front Door to Fender	5.0 +/- 1.0 // 1.0	+0.5 -1.5 Lower Area Underflush 1.0 +/- 1.0 Consistent within 1.0
-	Fender to Sill	4.5 +/- 1.5 // 1.0	+/- 1.0
6	Front Door To Windshield Molding (A-Pillar)	5.0 +/- 1.75 // 1.0	+/- 1.0 Consistent Within 1.0
7	Front & Rear Door to Roof	6.0 +/- 1.5 // 1.0	Overflush 2.0 +/- 2.0 // 1.5
8	Front & Rear Door To Sill	6.0 +/- 1.5 // 1.0	Underflush 1.0 +/- 1.0
9	Front Door to Rear Door	4.5 +/- 1.0 // 1.0	Excluding Door Header +/- 1.5
			Door Header +/- 1.0
			Front Door Lower Area Overflush 1.0 +/- 1.0 Consistent Within 1.0
10	Rear Door to Body Side	4.5 +/- 1.0 // 1.0	+/- 1.0 Consistent Within 1.0
11	Body Side to Fuel Filler	3.0 +/- 1.0 Consistent Within 1.0	Body Side 0.5 Overflush +/- 0.75
12	Liftgate to Body Side	4.0 +/- 1.0 // 1.0	Liftgate Underflush 1.0 +/- 1.0 Consistent Within 1.0
13	Liftgate to Rear Fascia	7.0 +/- 1.5 // 1.5	N/A
14	Liftgate to Roof	8.0 +/- 1.5 // 1.5	Liftgate Underflush 1.0 +1.0 -2.0 Consistent Within 1.5
NOTE: NOTE: ALL MEASUREMENTS ARE IN mm