Seat Belt Cinch Bar: Removal

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Cinch Bar Cover Remove

GC0023025

Courtesy of DAIMLERCHRYSLER CORP.

Before removing the cinch bar, verify that the cinch bar holds the belt from sliding through the latch plate. (Refer to ELECTRICAL/RESTRAINTS/SEAT BELT CINCH BAR - STANDARD PROCEDURE - SEAT BELT CINCH BAR VERIFICATION TEST) . If the cinch bar components are not present in the seat belt latch plate, go directly to the installation procedure. (Refer to ELECTRICAL/RESTRAINTS/SEAT BELT CINCH BAR - INSTALLATION) .

Using a small screwdriver or equivalent (1), release the two cinch bar cover catches (4).

Fig 2: Cinch Bar Remove
Courtesy of DAIMLERCHRYSLER CORP.
Remove and discard the cinch bar cover (1), the cinch bar (4) and the two small springs (3).