LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 112 (Restraints System (Service Information)) >> Satellite Acceleration Sensor >> Removal >> Side Mounted

Side Mounted

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: REMOVING/INSTALLING SIDE MOUNTED SATELLITE ACCELERATION SENSOR (SAS)
GC0043803Courtesy of DAIMLERCHRYSLER CORP.
  1. Disconnect and isolate the battery negative cable remote terminal.
    WARNING: Wait two minutes for the airbag system reserve capacitor to discharge before beginning any airbag system or component service. Failure to do so may result in accidental airbag deployment, personal injury or death.
  2. Remove the lower B-pillar trim from the appropriate side of the vehicle (Refer to BODY/INTERIOR/B-PILLAR TRIM - REMOVAL) .
  3. Disconnect the SAS electrical connector (3).
  4. Remove the SAS retaining screws (2) and remove the sensor (1) from the vehicle.
scientia non olet · About LEMON Manuals