Side Mounted

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: REMOVING/INSTALLING SIDE MOUNTED SATELLITE ACCELERATION SENSOR (SAS)

Courtesy of DAIMLERCHRYSLER CORP.

Position the Satellite Acceleration Sensor (SAS) (1) in B-pillar (electrical connector (3) facing down in vehicle) and install the retaining nuts (2). Tighten the nuts to 8 N.m (70 in. lbs.).
Connect the SAS electrical connector (3).
Install the lower B-pillar trim (Refer to BODY/INTERIOR/B-PILLAR TRIM - INSTALLATION) .

WARNING: Do not connect the battery negative cable (Refer to ELECTRICAL/RESTRAINTS - DIAGNOSIS AND TESTING - AIRBAG SYSTEM) . Personal injury or death may result if the system test is not performed first.