LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 112 (Restraints System (Service Information)) >> Satellite Acceleration Sensor - Pt27 >> Installation

Satellite Acceleration Sensor - Pt27: Installation

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Satellite Acceleration Sensor - Remove/Install
GC0023018Courtesy of DAIMLERCHRYSLER CORP.
  1. Position the Satellite Acceleration Sensor (SAS) (5) in position.
  2. Install the retaining screws (1). Tighten the screws to 10.5 N.m (95 in. lbs.).
  3. Connect the SAS electrical connector (2).
  4. Install the quarter panel trim.
WARNING: Do not connect the battery negative cable (Refer to ELECTRICAL/RESTRAINTS - DIAGNOSIS AND TESTING - AIRBAG SYSTEM)  . Personal injury or death may result if the system test is not performed first.
scientia non olet · About LEMON Manuals