LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 112 (Restraints System (Service Information)) >> Rear Seat Belt Buckle - Pt27 >> Installation

Rear Seat Belt Buckle - Pt27: Installation

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Seat Belt Buckle Anchor Bolt
GC0023014Courtesy of DAIMLERCHRYSLER CORP.
  1. Pull cushion cover back far enough to get at the seat belt buckle anchor bolt.
  2. Position the seat belt buckle into position and install the anchor bolt (1). Tighten bolt to 40 N.m (30 ft. lbs.).
    Fig 2: Rear Seat Cushion Cover/Shield
    GC0023015Courtesy of DAIMLERCHRYSLER CORP.
  3. Install the two screws at the bottom of the cushion cover (1).
  4. Install the two screws at the side of the seat cushion shield (1) at the buckle area.
  5. Return the rear seat to the unfolded position.
  6. Close door and decklid.
scientia non olet · About LEMON Manuals