LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 112 (Restraints System (Service Information)) >> Rear Seat Belt & Retractor - Pt27 >> Removal

Rear Seat Belt & Retractor - Pt27: Removal

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Seat Belt Anchor Nut
GC0023012Courtesy of DAIMLERCHRYSLER CORP.
  1. Release hood latch and open hood.
  2. Remove the lower seat belt anchor nut (1).
    Fig 2: Removing/Installing Seat Belt & Retractor
    GC0023013Courtesy of DAIMLERCHRYSLER CORP.
  3. Remove the Lower Quarter Trim Panel the side in which you are removing the seat belt and retractor.
  4. Remove the four bolts to the rear seat upper bolster.
  5. Feed the seat belt webbing (1) through the top of the bolster.
  6. Remove the one retaining bolt (2) to the seat belt retractor.
  7. Remove seat belt and retractor from vehicle.
scientia non olet · About LEMON Manuals