LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 112 (Restraints System (Service Information)) >> Rear Seat Belt & Retractor - Pt27 >> Installation

Rear Seat Belt & Retractor - Pt27: Installation

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Seat Belt & Retractor
GC0023013Courtesy of DAIMLERCHRYSLER CORP.
  1. Position seat belt & retractor into vehicle.
  2. Install the one retaining bolt to the seat belt retractor (2). Torque bolt to 40 N.m (30 ft. lbs.).
    Fig 2: Removing/Installing Seat Belt Anchor Nut
    GC0023012Courtesy of DAIMLERCHRYSLER CORP.
  3. Feed the seat belt webbing through the top of the rear seat upper bolster.
  4. Install the four bolts to the rear seat upper bolster.
  5. Install the Lower Quarter Trim Panel.
  6. Install the lower seat belt anchor nut (1). Torque bolt to 40 N.m (30 ft. lbs.).
scientia non olet · About LEMON Manuals