LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 112 (Restraints System (Service Information)) >> Rear Center Seat Belt And Retractor >> Installation

Rear Center Seat Belt And Retractor: Installation

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
  1. Feed webbing and hardware through seat frame and install retractor.
  2. Install retractor bolt and tighten to 40 N.m (30 ft. lbs.).
  3. Connect locking cable to retractor.
  4. Unlock seat back latch.
  5. Re-trim rear seat back cover (Refer to BODY/SEATS/SEAT BACK COVER - INSTALLATION) .
  6. Install seat bezel.
  7. Attach Quick Connect Anchor.
scientia non olet · About LEMON Manuals