LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 112 (Restraints System (Service Information)) >> Passenger Airbag Cover >> Removal

Passenger Airbag Cover: Removal

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Passenger Airbag Retaining Nuts
GC0023009Courtesy of DAIMLERCHRYSLER CORP.
  1. Open hood.
  2. Disconnect and isolate the battery negative cable.
    WARNING: Wait two minutes for the airbag system reserve capacitor to discharge before beginning any airbag system or component service. Failure to do so may result in accidental airbag deployment, personal injury or death.
  3. Remove the passenger airbag from the vehicle (Refer to ELECTRICAL/RESTRAINTS/PASSENGER AIRBAG - REMOVAL) .
  4. Unsnap cover from passenger airbag and remove by lifting the airbag cover up towards the hinge.
  5. Reach in under the cover and push down on the metal flap running the length of the top of the airbag housing.
  6. Maneuver airbag cover out of the airbag housing.
scientia non olet · About LEMON Manuals