LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 112 (Restraints System (Service Information)) >> Driver Airbag >> Installation

Driver Airbag: Installation

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Wiring Connectors To Driver Airbag And Speed Control
GC0042944Courtesy of DAIMLERCHRYSLER CORP.
  1. Place the driver airbag (3) into the steering wheel (1) opening, connect the squib wires (2) to the driver airbag (3). Make airbag connection by pressing straight in on the connector. The connector should be fully seated. Feel for positive snap to assure positive connection. Connect the speed control connector (4 and 5).
    Fig 2: CENTER BOTTOM LOOP DRIVER AIRBAG
    GC0043793Courtesy of DAIMLERCHRYSLER CORP.
  2. Hook the lower center loop first.
    Fig 3: UPPER DRIVER AIRBAG LOOPS
    GC0043794Courtesy of DAIMLERCHRYSLER CORP.
  3. Roll the driver airbag up and hook the upper two loops (2) to the steering wheel hooks (1).
WARNING: Do not connect the battery negative cable (Refer to ELECTRICAL/RESTRAINTS - DIAGNOSIS AND TESTING - AIRBAG SYSTEM)  . Personal injury or death may result if the system test is not performed first.
scientia non olet · About LEMON Manuals