LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 112 (Restraints System (Service Information)) >> Driver Airbag Cover >> Removal

Driver Airbag Cover: Removal

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Unlatching Driver Airbag Cover
GC0023001Courtesy of DAIMLERCHRYSLER CORP.
  1. Open hood.
  2. Disconnect and isolate the battery negative cable.
    WARNING: Wait two minutes for the system reserve capacitor to discharge before servicing any airbag components.
  3. Remove the driver airbag (Refer to ELECTRICAL/RESTRAINTS/DRIVER AIRBAG - REMOVAL) .
  4. With driver airbag removed, pick a corner and push down on the inflator or latch hook mounting plate (1) until the latch hooks (2) push out of the driver airbag cover (3).
    Fig 2: Driver Airbag Cover
    GC0022999Courtesy of DAIMLERCHRYSLER CORP.
  5. Remove driver airbag trim cover from driver airbag.
scientia non olet · About LEMON Manuals