Vapor Canister: Installation

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Vapor Canister Bracket Tabs

Courtesy of DAIMLERCHRYSLER CORP.

1 - TABS

Install EVAP canister over bracket tabs.
Push canister back and into the bracket until the spring clips snap over the edge of the canister.

Fig 2: Identifying EVAP Canister & Push Pin
Courtesy of DAIMLERCHRYSLER CORP.

1 - PUSH PIN
Install the push pin through the EVAP canister and the bracket and into the fuel tank.

Fig 3: Identifying EVAP Canister & LDP
Courtesy of DAIMLERCHRYSLER CORP.

1 - LDP

2 - EVAP CANISTOR
Install hoses and lines.
Install the fuel tank and EVAP system, (Refer to FUEL SYSTEM/FUEL DELIVERY/FUEL TANK - INSTALLATION) .
Lower vehicle.
Install the negative battery cable.
Install the air cleaner lid, connect the inlet air temperature sensor and makeup air hose.
Fill fuel tank. Use the DRBIII® scan tool to pressurize the fuel system. Check for leaks.