Diagnosis And Testing - Vehicle Does Not Fill
WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
| CONDITION | POSSIBLE CAUSES | CORRECTION |
|---|---|---|
| Pre-Mature Nozzle Shut-Off | Defective fuel tank assembly components. | Fill tube improperly installed (sump) |
| Fill tube hose pinched. | ||
| Check valve stuck shut. | ||
| Control valve stuck shut. | ||
| Defective vapor/vent components. | Vent line from control valve to canister pinched. | |
| Vent line from canister to vent filter pinched. | ||
| Canister vent valve failure (requires double failure, plugged to NVLD and atmosphere). | ||
| Leak detection pump failed closed. | ||
| Leak detection pump filter plugged. | ||
| On-Board diagnostics evaporative system leak test just conducted. | Canister vent valve vent plugged to atmosphere. | |
| Engine still running when attempting to fill (System designed not to fill). | ||
| Defective fill nozzle. | Try another nozzle. | |
| Fuel Spits Out Of Filler Tube. | During fill. | See Pre-Mature Shut-Off. |
| - | At conclusion of fill. | Defective fuel handling component. (Check valve stuck open). |
| Defective vapor/vent handling component. | ||
| Defective fill nozzle. |