LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 111 (Emission Control System) >> Evaporative Emissions >> EVAP/Purge Solenoid >> Installation >> 1.6/2.0L

EVAP/Purge Solenoid: Installation: 1.6/2.0L

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

The top of the solenoid has TOP printed on it. The solenoid will not operate unless it is installed correctly.

  1. Connect vacuum tube to solenoid.
  2. Connect electrical connector to solenoid.
  3. Install solenoid on bracket.
  4. Install the negative battery cable.
scientia non olet · About LEMON Manuals