2.4L Turbo

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Throttle Control Shield

Courtesy of DAIMLERCHRYSLER CORP.

Disconnect the negative battery cable.
Remove the throttle control shield. See Fig 1.

Fig 2: Throttle Cables
Courtesy of DAIMLERCHRYSLER CORP.
Remove the throttle cables from the throttle body lever. See Fig 2.

Fig 3: Throttle Cable Bracket
Courtesy of DAIMLERCHRYSLER CORP.
Remove the throttle cable bracket and relocate. See Fig 3.
Remove the spark plug cables from the ignition coil.
Unlock and disconnect the electrical connector from the ignition coil.

Fig 4: Removing/Installing Bolts From Ignition Coil
Courtesy of DAIMLERCHRYSLER CORP.
Remove bolts from ignition coil. Twist coil to remove 2 of the bolts from the coil before removing it from vehicle. See Fig 4.

Fig 5: Positioning Ignition Coil For Removal/Installation
Courtesy of DAIMLERCHRYSLER CORP.
Rotate coil and tip upward.

Fig 6: Removing/Installing Ignition Coil
Courtesy of DAIMLERCHRYSLER CORP.
Pull coil up and out by the throttle body side of the intake manifold. See Fig 5.Fig 6.