Junction Block: Installation

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Junction Block and Brake Tubes

Courtesy of DAIMLERCHRYSLER CORP.

Install junction block (5), pushing mounting bracket down into mounting grommets (8) located in body of vehicle.

Fig 2: Rear Tubes at Junction Block
Courtesy of DAIMLERCHRYSLER CORP.
Install brake tubes to rear (1 and 3) at hydraulic control unit. Tighten tube nuts to 20 N.m (177 in. lbs.) torque.

Fig 3: Junction Block and Brake Tubes
Courtesy of DAIMLERCHRYSLER CORP.
Install brake tubes (1, 2, 3 and 10) at junction block (5). Tighten tube nuts to 20 N.m (177 in. lbs.) torque.
Remove brake pedal holding tool.

Fig 4: Disconnecting/Connecting Battery Cables
Courtesy of DAIMLERCHRYSLER CORP.
Connect battery negative cable (2) to battery post. It is important that this is performed properly. (Refer to ELECTRICAL/BATTERY SYSTEM - STANDARD PROCEDURE)

Fig 5: Bleeding Brakes
Courtesy of DAIMLERCHRYSLER CORP.
Fill and bleed (1) base brake hydraulic system. (Refer to BRAKES - STANDARD PROCEDURE)
Road test vehicle to verify proper operation of brakes.