LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 109 (1.6L Engine - DTCS P127D To P2135) >> Diagnosis And Testing >> P2107-Electronic Throttle Control Module Processor >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
  1. 1)  REPROGRAM THE POWERTRAIN CONTROL MODULE 

    Turn the ignition on.

    Using the scan tool, attempt to reprogram the Powertrain Control Module in accordance with the Service Information.

    Start the engine.

    Allow the engine to reach normal operating temperature.

    Operate the accelerator pedal. (do not exceed 3500 RPM)

    With the scan tool, read DTCs.

    Does this DTC reset? 

    Yes 

    1. Replace and reprogram the Powertrain Control Module in accordance with the Service Information. (Refer to STANDARD PROCEDURE - PCM/ECM/SKREEM PROGRAMMING) .
    2. Perform the POWERTRAIN VERIFICATION TEST. (Refer to STANDARD PROCEDURE - POWERTRAIN VERIFICATION TEST) .

    No 

    1. Test Complete.
scientia non olet · About LEMON Manuals