SENSOR, Manifold Air Pressure (MAP): Installation: 2.7L

Fig 1: MAP Sensor And O-Ring

Courtesy of CHRYSLER LLC

1. Clean MAP sensor mounting hole at intake manifold.
2. Check MAP sensor o-ring seal for cuts or tears.
   Fig 2: Removing/Installing MAP Sensor

   Courtesy of CHRYSLER LLC
3. Position sensor into intake manifold.
   Fig 3: MAP Sensor Electrical Connector

   Courtesy of CHRYSLER LLC
4. Rotate sensor 1/4 turn clockwise for installation.
   Fig 4: Locating Manifold Air Pressure (MAP) Sensor

   Courtesy of CHRYSLER LLC
5. Connect electrical connector to sensor.
6. Lock electrical connector.
7. Connect negative battery cable.