LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 3.5L Engine (Service Information) >> Engine Block >> BEARING(S), Connecting Rod >> Standard Procedure >> Connecting Rods And Bearings >> Connecting Rod Bolts

Connecting Rod Bolts

Fig 1: Check for Stretched Bolts
GC0081704Courtesy of CHRYSLER LLC
1 - STRETCHED BOLT
2 - THREADS ARE NOT STRAIGHT ON LINE
3 - THREADS ARE STRAIGHT ON LINE
4 - UNSTRETCHED BOLT
  1. Examine connecting rod bolts for stretching (1). Stretching (1) can be checked by holding a scale or straight edge against the threads. If all the threads do not contact the scale the bolt must be replaced.
  2. Before installing the bolts the threads should be cleaned and inspected.
  3. Install clean bolts finger tight. Then alternately torque each bolt to assemble the cap properly.
  4. Tighten the connecting rod cap bolts to specification. See Engine - Specifications .
scientia non olet · About LEMON Manuals