COVER(S), Cylinder Head, Right: Removal: Removal

Fig 1: Ignition Coils - Right Cylinder Head

Courtesy of CHRYSLER LLC

WARNING: DO NOT START OR RUN ENGINE WITH CYLINDER HEAD COVER REMOVED FROM THE ENGINE. DAMAGE OR PERSONAL INJURY MAY OCCUR.

1. Disconnect and isolate the negative battery cable.
2. Remove the upper intake manifold. See Engine/Manifolds/MANIFOLD, Intake - Removal .
3. Cover lower intake manifold openings during service.
4. Disconnect and remove the three ignition coils (2). Refer to Electrical/Ignition Control/COIL, Ignition - Removal .
5. Lift up on the wire harness track retaining tabs (4).
6. Remove the ground strap retaining bolt (3) from the cylinder head cover.
7. Completely loosen the cylinder head cover retaining bolts and remove the cylinder head cover.