LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> Electrical >> Gauges >> Overhead Console (Service Information) >> SENSOR, Ambient Temperature >> Diagnosis and Testing >> Ambient Temperature Sensor >> Sensor Test

Sensor Test

  1. Turn the ignition switch to the Off position. Disconnect and isolate the battery negative cable. Disconnect the ambient temperature sensor harness connector.
  2. Measure the resistance of the ambient temperature sensor. At - 40° C (- 40° F), the sensor resistance is 336 kilohms. At 55° C (130° F), the sensor resistance is 2.488 kilohms. The sensor resistance should read between these two values. If OK, refer to SENSOR CIRCUIT TEST . If not OK, replace the inoperative ambient temperature sensor.
scientia non olet · About LEMON Manuals