ROTOR, Brake: Removal: Front

NOTE: Before proceeding. Refer to:

Raise and support vehicle. Refer to Vehicle Quick Reference/Hoisting - Standard Procedure

Fig 1: TIRE AND WHEEL MOUNTING
Courtesy of CHRYSLER LLC
Remove wheel mounting nuts(3), then tire and wheel assembly (1).
NOTE: In some cases, it may be necessary to retract caliper piston in its bore a small amount in order to provide sufficient clearance between shoes and rotor to easily remove caliper from knuckle. This can usually be accomplished before mounting bolts are removed, by grasping rear of caliper and pulling outward working with guide pins, thus retracting piston. Never push on piston directly as it may get damaged.

Fig 2: FRONT CALIPER AND ADAPTER MOUNTING - AWD
Courtesy of CHRYSLER LLC
AWD - Remove two bolts (1) securing disc brake caliper and adapter (2) to knuckle (3).
AWD - Remove disc brake caliper and adapter (2) from knuckle (3) as an assembly. Hang assembly out of way using wire or a bungee cord. Use care not to overextend brake hose when doing this.

Fig 3: FRONT CALIPER AND ADAPTER MOUNTING
Courtesy of CHRYSLER LLC
RWD - Remove two bolts (2) securing disc brake caliper and adapter (3) to knuckle (1).
RWD - Remove disc brake caliper and adapter (3) from knuckle (1) as an assembly. Hang assembly out of way using wire or a bungee cord. Use care not to overextend brake hose when doing this.

Fig 4: VENTED BRAKE ROTOR MOUNTING
Courtesy of CHRYSLER LLC
Remove any clips (3) retaining brake rotor (2) to wheel studs.
Slide brake rotor (2) off hub and bearing (1).