SENSOR, Intrusion Module, Export: Removal: Transmitter

Fig 1: Removing/Installing Bezel

Courtesy of CHRYSLER LLC

1. Disconnect and isolate the battery negative cable.
2. If replacing the bezel, pull the bezel (1) inboard from the C-pillar (3), or use a trim stick or equivalent to unsnap it from the transducer housing (2) of the intrusion sensor transmitter.
3. Remove the C-pillar trim panel. Refer to Body/Interior/PANEL, C-Pillar Trim - Removal .
4. Remove the two retaining screws from the C-pillar and remove the sensor.