Diagnostic Test

TEST FOR INTERMITTENT CONDITION
1. Turn the ignition on.
2. With the scan tool, record and erase DTCs.
3. Turn the ignition off and remove the key from the ignition.
4. Close all doors and arm the VTSS and wait 2 minutes.
5. Disarm the VTSS turn the ignition on.
6. Turn the ignition on and with the scan tool, read DTCs.
  Does the scan tool display this DTC as active?
  
  Yes
  - Go to Step 2.
  No
  - The conditions that caused this code to set are not present at this time. Using Figure as a guide, inspect the wiring and connectors.
  - Perform the BODY VERIFICATION TEST. Refer to DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure .
INTRUSION SENSOR RECEIVER

Fig 1: Identifying Intrusion Sensor Receiver Connector
Courtesy of CHRYSLER LLC
1. Turn the ignition off.
2. Disconnect the Intrusion Sensor Receiver connector.
3. Turn the ignition on and with the scan tool, erase DTCs.
4. Turn the ignition off and remove the key from the ignition.
5. Close all doors and arm the VTSS and wait 2 minutes.
6. Disarm the VTSS turn the ignition on.
7. With the scan tool, read DTCs.
  Does the scan tool display this DTC as active?
  
  Yes
  - Replace the Intrusion Sensor Receiver.
  - Perform the BODY VERIFICATION TEST. Refer to DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure .
  No
  - Go to Step 3.
CHECK THE (G460) INTRUSION RECEIVER SENSOR SIGNAL CIRCUIT SHORT TO GROUND

Fig 2: Measuring Resistance Between Ground & Intrusion Receiver Sensor Signal Circuit At Intrusion Transceiver Module Connector
Courtesy of CHRYSLER LLC
1. Turn the ignition is off.
2. Disconnect the Intrusion Transceiver Module connector.
3. Measure the resistance between ground and the (G460) Intrusion Receiver Sensor Signal circuit at the Intrusion Transceiver Module connector.
  Is the resistance below 5.0 ohms?
  
  Yes
  - Repair the (G460) Intrusion Receiver Sensor Signal circuit for a short to ground.
  - Perform the BODY VERIFICATION TEST. Refer to DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure .
  No
  - Replace the Intrusion Transceiver Module in accordance with the Service Information.
  - Perform the BODY VERIFICATION TEST. Refer to DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure .