LAMP, Spot: Removal: Bulb
Courtesy of CHRYSLER LLC
- Remove the PDC cover and pull the fuse, depending on which spot lamp is being serviced.
- Raise the spot lamp from the stowed to the operating position.
- Support the spot lamp sealed beam in position.
- Remove the screws (1) retaining the bezel to the spot lamp head assembly.
- Remove the bezel from the spot lamp head assembly.
- Tilt the sealed beam (2) away from the spot lamp head assembly.
- Disconnect the electrical connector to the spot lamp head assembly.
- Remove the bulb from the lamp housing by moving the hold downs.
- Remove bulb from lamp.